Legal basics SinuTrain software is used for creating and simulating NC programs on a PC, on the basis of the DIN 66025 programming language as well the products ShopMill, ShopTurn and ManualTurn, and language commands of the type SINUMERIK 802D, 810D, 840D, 840Di. MS-DOS and WINDOWSTM are registered trademarks of the Microsoft Corporation. Trademarks IBM is a registered trademark of the International Business Corporation.
Note This symbol always appears in this documentation where further, explanatory information is provided. Notice This symbol indicates that an undesirable result or state may result if proper precautions are not taken. Property may result if proper precautions are not taken.Ĭaution This symbol (without a warning triangle) indicates that damage to property may result if proper precautions are not taken. ! Caution This symbol (with a warning triangle) indicates that minor injury or damage to All rights reserved EN/iv SinuTrain Getting Started (BAK) 01.05 Edition ! Warning This symbol indicates that death, severe personal injury or substantial propertyĭamage may result if proper precautions are not taken. ! Danger This symbol indicates that death, severe personal injury or substantial property damage will result if proper precautions are not taken. Hotline Should you have any questions about the software, please contact the following hotline: A&D Technical Support Phone: +49 (0) 180 / 5050 - 222 Fax: +49 (0) 180 / 5050 - 223 Should you have any questions about the documentation, please contact: Fax: +49 (0) 9131 / 98 - 2176 E-mail: and warning concept The following danger and warning symbols are used in this document: Sales staff for the purpose of giving customer presentations Who is the SinuTrain CD designed for? This multimedia SinuTrain CD has been designed for the training and further training of: Beginners, new users Ordering information appears in the Appendix to this Manual. Working with the examples provided If you want to further your knowledge, we recommend studying the training booklets, which have been specially developed for the training CD. Getting Started guides you step-by-step through the following tasks: Installing the training software from the CD Welcome to Getting Started for the SinuTrain PC-based Training and Programming CD, which will enable you to operate and program SINUMERIK 802D/810D/840D/840Di controllers. All rights reserved SinuTrain Getting Started (BAK) 01.05 Edition EN/iii Subject to change without prior notice.Ī5E 0039 1242 001 Siemens Aktiengesellschaft The information contained in this document is, however, reviewed regularly and any necessary changes will included in the next edition. Nonetheless, differences might exist and therefore we cannot guarantee that they are completely identical. We have checked that the content of this document correspond to the hardware and software described. Additional Information is available on the Internet under: This documentation was produced with WinWord V 8.0 Siemens AG, 2004.
0 kommentar(er)
